Aluminum veneer manufacturers will introduce four common problems often encountered during installation

For aluminum veneer manufacturers, raw materials and processes determine the quality of aluminum veneer products. Whether the installation of aluminum veneer is professional has become the key to determining the quality of the project. As the saying goes, three parts manufacturing and seven parts installation. Without serious and responsible scientific installation and construction, no matter how good the product is, it will not achieve the expected decorative effect.

The installation of aluminum veneer is a highly technical job. Unprofessional construction may cause the unevenness of the entire aluminum veneer curtain wall, thereby destroying the beauty of the entire aluminum veneer curtain wall and even affecting the safety of the building. So what common problems will be encountered during the installation of aluminum veneer today? At this time, aluminum veneer manufacturers will introduce four common problems and solutions often encountered during the installation process, hoping to help everyone.

One is that the board surface is uneven, not vertical, the joint width is narrow, and the height is inconsistent

1. Careful operation must be carried out when installing embedded parts and expansion bolts. When installing the skeleton, make horizontal and vertical wire drawing, the plane must be flat, and then use the theodolite to check the process acceptance.

2. The positioning and drilling of aluminum plates and skeletons must be accurate.

3. During the installation of aluminum veneers, arbitrary installation is not allowed, and the installation construction must be carried out strictly in accordance with the requirements of the installation drawings and the position of the elastic line. Before installing the aluminum veneer, the size and shape of the plate should be checked and only installed after it is correct.

Second, the joints are not tightly sealed, uneven, with bubbles and water seepage.
1. When caulking, the back of the board is not blocked with polyethylene foam, and a certain pressure is not formed when the sealant is poured into the caulking, so that the board joints are not firmly bonded and the seal is not tight.
2. The on-site installation workers are not skilled in operation, the spacing at the caulking is inconsistent, and the pressure is uneven, resulting in uneven thickness, many joints, and air, which causes the sealant surface to be uneven, bubbles, and water seepage.
3. There are problems with the material quality of silicone sealant.
4. Carefully insert the sealing filler, the distance between the filling surface and the board surface is consistent, and the depth of the embedded sealant is consistent, so that the joints are dense and the joint surface is straight.
5. The installer should caulk the joints skillfully and steadily, maintain a consistent distance, and as the air is embedded, once bubbles appear, they will burst, and the air will be smoothed with a trowel.
Third, the closing treatment is not firm, smooth, and dense.
1. Before installing the aluminum veneer, a closing plan should be prepared, and a reasonable closing plan should be adopted for different structures and situations.
2. When installing aluminum veneers, strict and standardized operations are required to master the essentials.

Fourth, the surface of aluminum veneers is polluted and sunken.

1. The protective film is removed too early, and the finished product protection measures are improper.

2. The finished product is improperly protected during the installation of the next process, causing the board surface to be impacted.

3. Do not remove the protective film too early, it is better to remove it when removing the scaffolding.

4. When installing aluminum veneers, practical and feasible finished product protection measures should be formulated.

5. Clean and scrub the contaminated areas in time.