1. The design concept of the decorative column with the U -shaped narrow curtain wall aluminum board
In the curtain wall design, we often encounter aluminum decorative columns, which are limited by space and structure. Such a decorative column can not be installed at the seam, and there is no way to install the skeleton. The aluminum board on the curtain wall can only be fixed on both sides. In this way, after the installation of the curtain wall aluminum veneer is completed, the aluminum plate of the decorative column of the upper and lower curtain wall will be shifted. Once such a thing happens, it is difficult to adjust the aluminum plate. Even if it was adjusted properly at that time, due to thermal expansion and contraction and the wind load, the aluminum plate would move with the changes in the ambient temperature.
In this case, some installation companies choose the corner code of the two aluminum veneers of the curtain wall to connect together, and use the corner code to limit the inner and outer position of the irrigated glue foam stick. However, the corner code cannot guarantee accuracy. The corner code is also easy to deform, which is not conducive to the overall restrictions.
2. Price of aluminum square mesh. Super large corner curtain wall aluminum veneer spray
The design of aluminum veneer on the curtain wall cannot be compared with other panel materials. Usually the aluminum plate on both sides or above the corner of the building curtain wall is a unit, and the corner is not set up like a glass. In that case, the shape of the aluminum single board for the curtain wall will be very large, which will bring a certain difficulty factor to production and processing. When we design the aluminum board on the curtain wall, we will encounter such a situation. After the production and processing of aluminum plates, it is limited by the manufacturer's aluminum spray oven opening. The horizontal specifications of the aluminum plate are slightly large and there is no way.
3. Connection of corner curtain wall aluminum veneer
Sometimes the price board of the corner aluminum single aluminum ceiling flow line equipment is limited by the original aluminum plate material, and an aluminum plate is incomplete. In this case, the curtain wall aluminum veneer factory usually uses edge welding process for production and processing.
In order to reduce the welding problem of the curtain wall aluminum veneer, many manufacturers of the curtain wall aluminum veneer have formulated many embodiments, such as intermittent welding of the joints. Some also use screw connections, that is, fold the aluminum plate into two 45 cents, and then connect with screws. In this way, there are two defects in processing. First, the screw connection holes cannot be produced and processed together. The holes in the pre -wood -grained aluminum square installation renderings are very easy to deviate and not match. First, the aluminum plate has a rounded corner. The thread connection requires a certain amount of space. The thread connection is far from the plate surface, which is easy to open. It is easy to crack even if it is sealing with glue, and the quality of the product is not good.
4. Design ideas of curtain wall aluminum veneer slippery
In the curtain wall design, the curtain wall aluminum veneer is usually connected to the glass curtain wall and the glass window. Once the curtain wall is opened or glass windows are covered by the curtain wall aluminum veneer, the design concept of the curtain wall aluminum veneer must also take into account the dripping problem. The common form of design concept is to design a flowing sink on the curtain wall aluminum veneer. In addition, the curtain wall aluminum veneer with an embedded flowing water is also installed.
